LED ceiling features and installation and use

time2011-11-02

  LED Ceiling Lamp Features:
  High luminous efficiency, low power consumption, long life, easy to control, maintenance, safety and environmental protection, is a new generation cold light source, than the tube-shaped energy-saving lamps, high brightness, cast Guangyuan, cast light performance, using a wide voltage range , the light source built by microcomputer controller, can realize seven colors change LED light color and soft, bright, colorful, low loss, low energy consumption, green.
  LED Ceiling installation and use:
  As the heat continues to heat up home decoration, ceiling changes with each passing day, the past is no longer confined to a single lamp, and to diversify not only learned a chandelier of luxury and style, but with a ceiling of the installation, avoid the lower room can not hold a large luxury lighting defects. LED ceiling light body mounted directly on the roof, suitable for general lighting, typically used for the living room and bedroom.
  LED Ceiling Lamp in the installation and use should note the following:
  1, installed in a masonry ceiling should be used embedded bolts or expansion bolts, nylon or plastic plugs plug fixed; not use wedge. And the carrying capacity of the fixed pieces of the weight should match the ceiling. Ceiling fixed to ensure solid, reliable, and extend their useful life.
  2, when using expansion bolts, they should be asked to select the technology products bolt specifications, the hole diameter and depth of burial in line with the bolt size.
  3, the number of fixed-holder should not be less than the lighting bolt on the base of the fixed number of holes, and bolt hole diameter should match; no fixed mounting holes on the base of the lamp (self-drilling installation), each lamp for fixed bolts or screws should not be less than 2, and the lighting of the center of gravity to the center of the bolt or screw is consistent; only when 75mm in diameter, insulated units and below, only the use of a bolt or screw.
  4, LED ceiling can not be directly mounted on flammable objects, some families after the paint for aesthetic use in the ceiling plywood lining behind, in fact, it is very dangerous to take insulation measures; if the surface temperature location close to the lamp combustible materials, they should also take heat or cooling measures.
  5, LED Ceiling Lamp should be checked prior to installation:
  ① Each lamp lead wire core wire cross-section, copper cord is not less than 0.4mm2, copper not less than 0.5mm2, or lead must be replaced.
  ② wire connection with the lamp, lamp wire should be connected in parallel between the firm, should be good electrical contact, in order to avoid exposure to bad, there wires and sparks between the terminals, and dangerous. 6, to teach children not to throw in the indoor lighting balloons and other objects to avoid light falling on the ornaments hanging lamps hurt or affect the decorative effect.